Now with the development of society and the advancement of science and technology, people's requirements for the quality of life have also been greatly improved. Incandescent lamps and energy-saving lamps are gradually being phased out. In the future, people's main lighting will rely on LED lamps. Many families still Subjective character LED is just a kind of lighting, users do not have a clear concept of LED, indeed, LED is a lighting fixture, but in such cases, most home users still do not know LED module street lamp How to use, will miss a lot of details, so users need to pay attention to several aspects to use the LED module street lamp correctly.

How to use LED module street lamp 1. Storage
It is best to use the LED module street lamp within 3 months under the premise that the original packaging is intact to avoid rusting of the bracket. When the LED packaging bag is opened, it should be used up as soon as possible. The LED module street lamp should be stored in a dry and ventilated environment, the storage environment temperature should be controlled at 23±5℃, and the relative humidity should be controlled at 40-70%;

How to use LED module street lamp 2. Cleaning
It is forbidden to use unknown chemical liquid to clean the LED module street lamp, which may damage the surface of the LED resin, or even cause resin cracks. If necessary, please immerse the LED in alcohol at room temperature for cleaning within one minute. The care of the LED module street lamp requires special liquid to clean, do not use it indiscriminately, the damage to the lamp is great.

How to use LED module street lamp 3. Forming and cutting of lead bracket
1. The molding position should be carried out in the department below the card point;
2. Please do not put pressure on the inside of the package shell when molding;
3. Forming should be carried out before welding;
4. The pin shearing of the product under high temperature will cause defects. Please perform pin shearing at room temperature.

How to use LED module street lamp 4. Installation matters
1. Where the circuit board is installed, the spacing between the mounting holes on the circuit board.
2. During the installation process, do not put any pressure on the lead frame.