The quality module street lamp is one of the important equipment for engineering lighting. To put it bluntly, the quality module street lamp should let the light wash the wall like water. It is mainly used for the construction of interior decoration lighting fixtures, and it is also used to describe large and medium-sized projects. The outline of the building. With the development trend of lighting fixtures, the role of quality module street lamps is getting better and better, and there are more and more methods. It is no longer limited to using concealed quality module street lamps. There are also different installation processes for quality module street lamps. different. Today, let's take a brief look at the installation process of several common quality module street lamps and the application fields of quality module street lamps.

1. First, use an electric soldering iron and solder bar to weld the LED lamp beads on the solar cell for reservation.
2. Then test the spot-welded wood board to see if there is empty welding or no light, so that according to the basic embrittlement, it can ensure that the promotion of the LED quality module street lamp and the LED lamp beads are intact.
3. After the light test is over, put heat-dissipating silica gel on the back of the solar cell, and put the board into the case. The heat-conducting silica gel is to release the attention of the LED lamp beads to the lamp arm, which can prevent the lamp from sub-light decay.
4. Prepare the process in advance. Weld the switching power supply on the positive and negative sides of the solar cell, and then bind the two sides with tape to carry out glue.
5. After the glue is made, cover the laminated glass to construct a moisture-proof quality module street lamp. There is no need to use structural glue. It is not a waterproof material, and structural glue must be used. After the laminated glass is covered, plug the leak head.

Engineering construction methods: 1. Insulation layer detection: Use a grounding shaker to monitor the grounding resistance between the wires and to the ground to check whether the cables are intact and whether there is electricity. The copper core cable should be charged and discharged to the ground. The top of the cable is sealed with a soft eraser cloth and then wrapped with tape. 2. Quality module street lamp installation: (1) The aspect ratio (from the light source to the road surface), elevation angle, and Andon orientation of the street lamps at the same location should be maintained - consistent. (2) The vertical axis of the lighting installation and the vertical axis of the pick arm should be the same, the horizontal line of the lighting fixture should be parallel to the floor, and it should be estimated that there should be no inclination after tightening. (3) The lamp socket is fixed and firm, the adjustable lamp socket should be adjusted to a reasonable position according to the design, and the lamp socket wiring should meet the requirements.